Canadian Dollars US Dollars

10KW Electric Sailboat drive system

$2,300.00 USD

SKU: 10KW saildrive

 Convert your 12-29 HP diesel engine to clean, quiet electric. Eliminate noxious diesel fumes and the frustration of filling up at the pump with the 10KW Brushless Kit featuring a Motenergy brushless motor and a 48V 450 Amp Sevcon Gen-4 Controller that can produce up to 10HP continuous and 28HP peak!  Enjoy your sailboat to the fullest, with a silent drive and truly fresh air.

We've supplied our electric drive systems for sailboats up to 30 ft. and 15,000 lbs. displacement, achieving hull speed. All our systems have reverse on-the-fly and contactor disable features. "Brushless" means that the motor does not have brushes that will wear out over time, nor will it be a dangerous source of ignition for on-board gas appliances. Larger boats may require a higher power AC or brushless motor. In the U.S. and Canada, brushed motors are only legal for marine use if onboard appliances and accessories use kerosene or diesel (not propane or gasoline) due to the potential for internal motor arcing. With Sevcon's Gen4 controller, no reversing contactors are needed. Additionally, the Gen-4 controller has a regen feature than can allow current to be put back into the batteries from the spinning prop while under sail. This does depend on your sailing speed, prop design, and may not be possible in all applications, but is an adored feature for those who are able to utilize it.
A gear reduction is not always necessary, and largely depends on the size, efficiency, prop style, and desired speed of your vessel. However, due to the high RPM of the Motenergy Brushless motor, we recommend you consider a gear reduction rather than direct-drive to improve efficiency, provide proper torque, cooling, and help prevent cavitation. Typical reduction is around 2:1, but this ratio will depend on the required prop RPM needed to reach hull speed. Ideal reduction will enable the motor to spin your prop at the hull speed RPM of your prop when the motor is spinning at its max RPM. This number can be calculated using the 50 RPM / Volt constant:48 Volts * 50 RPM / Volt ~ 2400 rpm max
If you choose not to use a gear reduction, it's important to install a thrust bearing somewhere in line with the prop shaft, as most motors are not rated for axial/thrust loads on the shaft. Also note that a heatsink for the Sevcon controller is recommended by the manufacturer.
Kit includes:
  • Motenergy ME 0913 Dual-Stator Brushless Motor
  • Controller: 48V Sevcon Gen-4 450Amp (can be set up to run at 36V), programmable, with regen - the kit includes free custom programming for your unique application!
  • Key switch and ET-134 throttle. For harsh environments we recommend the ET-134 as the most robust option. 
  • Tyco Contactor
  • Fuses
  • Every kit is individually bench tested
  • Complete wire harness with 10ft key and throttle cable lengths
  • Wiring instructions